ON DEMAND COMFORT LLC

Feb 2015

Oil to gas conversion. Installation of Bryant 925TS 60,000BTU 96% gas furnace with Honeywell PRO4000 thermostat. Dispose of old equipment. Reconnect existing electrical. Permit and drawing. New Vent. Condensate removal. Connect to existing ductwork. Pump oil out.

$5k

Portland, OR

Feb 2015

Installation of Bryant Air Conditioner model 113ANA 2 TON 13 SEER with a 2 TON cased coil .New heat run added upstairs New return air added upstairs

$4k

Portland, OR

Feb 2015

Install new Bryant 95%, 80,000BTU Model#915SA48080S17. Install gas pipe to furnace with stub at furnace for future range stub. Hook up existing line voltage and control voltage. Fabricate new sheet metal transitions. Install new filter door with filter rack. Remove existing equipment. Install new PVC venting directly to the outside at driveway with concentric kit.

$3k

Portland, OR

Feb 2015

Install New Bryant 96% 2 stage gas furnace with ECM motor Model #925TA48080E17. Install New Bryant 2.5 ton air conditioner with new coil and line set ran. Model#113ANA030000. Dispose of existing equipment, reconnect electrical, run new electrical to AC, New vents ran for furnace, new condensate pump, new equipment pad for AC, connect to existing duct work, modify cooling coil into existing duct work.

$6k

Portland, OR

Feb 2015

Changed out furnace and installed new Bryant furnace 915SA, 95%. Installed all new PVC venting out side wall.

$3k

Portland, OR

Feb 2015

Install new Trane TUH2B060A9V3VB 60,000 BTU variable speed furnace in the attic. Install new Trane AC 4TTR3024G1000A 2ton. New coil to match furnace and AC 2 ton Install complete duct system in attic. Filter grill will be located in hallway. New thermostat located in hallway. Platform built for equipment to sit on horizontal. Install gas lines: range stub, water heater stub, and gas line to the new furnace Electrical installed to the furnace, AC, light and plug in attic for service. Electrical permit New: Pan under equipment in attic, new condensate drain, venting for furnace, new line set ran to new AC, pad for AC, one heat run in each bedroom. living room, dinner room, each bathrrom. One return in hallway

$10k

Milwaukie, OR

Feb 2015

Remove existing oil furnace and recycle. Install Bryant 915SA 80,000BTU furnace. New electrical circuit ran from panel to new furnace. Permit and drawing. New exhaust and intake vents ran to the outside of home through joist bay. Condensate drain repaired to work properly. New metal transitions fabricated to adapt new furnace to existing ductwork. Recover refrigerant from heat pump to install the coil in the proper location on the new furnace. Weld back up refrigerant lines, charge system and verify the heat pumps proper operation. Increase the duct work heat run that supplies the north bedroom upstairs to get better air flow. Reduce the heat run size in the down stairs bedroom Move the location of the media filter for easy access for changing

$5k

Portland, OR

Dec 2014

Customer did not have any hot water. Found the limit switch to be bad. Removed old switch and replaced with new one.

$288

Oregon City, OR

Dec 2014

Removed old furnace and installed a new Bryant 925SA 5ton 80,000BTU furnace. Removed and capped old flu pipe. Installed new PVC pipe outside wall. Added valve and drip leg to gas pipe.

$3k

Portland, OR