Water Heaters Only, Inc

Dec 2017

This is an installation of a 50 gallon gas water heater to replace a failed unit covered by a home warranty. The water heater is a contractor grade, Bradford White, which comes with a warranty of it's own and can be serviced by Water Heaters Only, Inc.

$2k

Ladera Ranch, CA

Nov 2017

This project called for two 75 gallon gas water heaters to be installed with a crane. Water Heaters Only worked with the heavy machinery operators to deliver these new gas water heaters and remove the old ones. No job is too small for Water Heaters Only, Inc!

$4k

Danville, CA

Jan 2016

Water Heaters Only, Inc South San Francisco replace a 40 gallon leaking water heater at a single family residence with a new water heater of the same size. Our complete installation included installing earthquake strapping and bracing per the state earthquake requirements, install a new water shut off valve and hot and cold water lines. Securing the vent. Re-piping the gas line with a new flex line, a drip leg or sediment trap and a shut off valve. Install a drip pan with a drain line. Insulate the hot and cold water lines. Run the temperature/ pressure overflow pipe to an approved location and insulate the valve and piping. Finally we removed the old water heater and hauled it away for disposal. Our technician then lights the pilot on the water heater and makes sure the burner turns on the heat the water. While the water heater is heating up he will clean up the area around the water heater and pack up his tools. Finally out technician will go over all the aspects of the new water heater with the homeowner including how the unit operates, how our warranty works, why the WHO sticker on the water heater is so important and how long it will take for the unit the fully heat. A permit was obtained via the city and the inspection passed.

$1k

South San Francisco, CA

Jan 2016

Water Heaters Only, Inc South San Francisco completed a water heater repair for a 6 year old 40 gallon water heater that was not producing any hot water. Upon arrival our technician diagnosed unit to have a failed pilot assembly, as the pilot would not hold a flame and the unit was unable to heat the water. He was able to open up the burner chamber, removed the failed pilot assembly, install the new pilot assembly, ensure the burner chamber was clear of any debris and looked in good working condition. Our technician then resealed the burner chamber and light the pilot light. Once the pilot light was on, he set the temperature and watched to see the burner turn on. After the water heater has been heating up for a bit, he turned the temperature down to the lowest setting, the burner turned off as it should have, he then set the temperature at the recommended 120F degrees. The home owner checked the hot water in the house and they had nice hot flowing water again.

$350

South San Francisco, CA

Feb 2018

Installation of residential 75 gallon gas water heater.

$2k

Yorba Linda, CA

Oct 2017

This 50 gallon gas water heater was installed in an area that was difficult to access and two men were needed to fit it into place. In addition to the access issue, recirculation lines were installed so that the water will arrive at the faucets throughout the house quickly, eliminating the need to run the water until it gets hot.

$3k

Redwood City, CA